Can any1 tell me if this is a stock itr flywheel or no? if not what make is it?


Got d hang of this image thing at last, thanks for d help!

 

Definately not stock (stock doesn't have those holes on the perimeter).

Possibly something like a Toda.
Definately one of the lighter aftermarked flywheels.

What happened to your other thread?
https://honda-tech.com/zerothread?id=902031

 

It still kept on not showing the pictures on my browser, so i decided to start off again!

 

Actually, I don't blame ya.

 

That Flywheel is from an old modell of VW Beatle , you should get rid of it instantly !!! maybe I can offer you some pocket change for it so I can hang it on my wall

 

tilton clutch maybe?

 

good try! that was actually quite funny! i got ur filter when u read this give me a call so i get it!

 

not stock itr and not Toda...

 

Looks like this one. It's a Cusco.

 

I think Geratol is correct milio , they look the same even the holes they are all the same and all of them match up with yours !!!

Congratulations you have a Cusco Flywheel

 

defenetlly not a toda, looks like jermy., geratol is right. i think exedy ones looks the same too. but it looks closer to cucsco

 

It took me a while to identify mine because I was checking all the issues of Hyper Rev and the pictures used in there didn't match. I found out that the pictures were just generic Cusco pictures, not application specific.

IIRC in Hyper Rev Integra Vol. 2 there is a short article of an ITR set up by Cusco. They have pictures of the actual parts they used and that is where I spotted this flywheel. Nowhere else have I seen a flywheel with this hole pattern.

 

Hi guys,
I have a cusco flywheel and it's not like that.
I don't have those wholes in the centre of the fw