As some of you know I have built a bad *** Z6 head consisting of the following:

Port and polish
3 angle valve job
all new seals
Milled .020
Cometic Head gasket
Mr. Gasket gaskets

Crower Stage 3 cam
AEM cam Gear
1mm Over sized Valves (mad dog racing) Swirl polished
Zex Valve Springs
Crower Ti. Retainers
Mugen Valve cover
Venom Sheetmetal IM
ITR TB
Venom Fuel rail
450's
10.3 OBX wires
Msd cap
MSD coil
ALL NEW HARDWARE (146.43 worth)
Airmass header

Im sure im forgetting something... But now I start the block I also am in need for a D16y8 AEM FPR if anyone has one hit me up. Anyone have any suggestions what to do for a Block, I plan to spray 150+ of direct port N20 Inj. So anyhelp is appreciated! any comments are welcome the good and the bad!