Nissan 300zx T3 turbo....
Thread Starter
Joined: Jun 2002
Posts: 389
Likes: 0
From: Ont., Canada
Nissan 300zx T3 turbo....
What's the stock wastegate set at? Its .60/.63 t3 turbo, I've heard 7psi and 10psi...
Also, anyone running one of these on their b18b Integra, just wondering how you like the spool up and what numbers you are running?
Also, anyone running one of these on their b18b Integra, just wondering how you like the spool up and what numbers you are running?
Member
Joined: Oct 2001
Posts: 1,599
Likes: 0
From: Santa Barbara, California, usa
Re: Nissan 300zx T3 turbo.... (Full-Race Geoff)
jb weld it will be fine...
but as far as the wastegate psi... not sure...if its higher you can lower it.by adjusting the actuator arm(if its threaded) if not... bending actuator braket.. but sacrifice spool time....
but as far as the wastegate psi... not sure...if its higher you can lower it.by adjusting the actuator arm(if its threaded) if not... bending actuator braket.. but sacrifice spool time....
Thread
Thread Starter
Forum
Replies
Last Post
PrecisionH23a
Classifieds: Forced Induction
16
Jun 1, 2004 07:36 PM
