Anyone know what the size of the crank journals should be in a d16a6?
Thread Starter
Joined: Dec 2003
Posts: 213
Likes: 0
From: Albuquerque, New Mexico, USA
Anyone know what the size of the crank journals should be in a d16a6?
Im putting all new bearing in my motor and lost my book and need to know whats the stock size of the crank journals in my d16a6, to make sure there not too far gone, if anyone can help that would be great thanks.
Member
Joined: Jun 2003
Posts: 2,262
Likes: 0
From: Somewhere in the lower part of, MI, U.S.A
Re: Anyone know what the size of the crank journals should be in a d16a6? (Wes90civic)
2.1644in-2.1654in (54.967mm-55.00mm)
good luck with the car dude
for a good buyer
good luck with the car dude
for a good buyer
Thread Starter
Joined: Dec 2003
Posts: 213
Likes: 0
From: Albuquerque, New Mexico, USA
Re: Anyone know what the size of the crank journals should be in a d16a6? (Sideout)
thanks for the info sideout, ya my car has been down, cause after i did the head and mani swap i replaced the rings and rod bearing, but i got lazy and didnt do the mains, well they went out after a week, lol, i guess it was too much stress for the worn out bearings, my luck sucks.
Thread
Thread Starter
Forum
Replies
Last Post