Im building an allmotor d16y7 for a friend (ARAXIS on the board), please keep in mind that we are poor and live in a country were everybody is poorer than us, so its going to be a little bit ghetto and if you wonder why we didnt go the B series route its because there arent any here and importing one is too much dough for our poor asses. At least were are building it!!!! (nobody else her has any serious allmotor d series cars)

D16Y7
P29 pistons from the junkyard (12:1 Cr but we have 95 octane)
y8 head gasket
new rings and a fesh hone
delta 272 camshaft
cheap arospeed 4-2-1 header cut at 2.25 inch and custom exhaust with mandrel bends and a cheap fireball knock off (it will be a bit loud )
portwork done by I dont know who yet, maybe myself with the dremel but I dont know yet, depends on cash flow and I dont think nobody here knows how to port honda heads very well they just hogg the **** out of them
z6 IM
b, f or h series TB from the junkyard or any donations??? (60mm and up)
afc
cam gear
fuel press reg
lightened flywheel

What do you guys think? Im hoping for 140~150whp. hope its not too bad for a daily driver with the high compression (remember the 95 octane afc and some dyno tuning)

Any dondations would be appreciated thanks

 

For south american all motor monster.


Modified by BeeBeeOne at 6:29 PM 3/5/2004

 

ha ha thanks

 

free bump, to a fellow N/A SOHC builder, good luck...

 

will it be too bad for a daily driver? I live in a climate very similar almost exact assouth africa and we have 95 octane fuel. Anyone from south africa has any suggestions? I think Bisimoto is from there and also a 1.4 with like 200whp is from there. Could you please share your thoughts and experiences.

 

TTT someone please help, anybody runing P29 pistons on Dseries motors (except on DOHC )

 

Doesnt the Y8 IM Flow better than the Z6?

 

check d-series.org, all the info you need

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 1point5CRX &raquo;</TD></TR><TR><TD CLASS="quote">check d-series.org, all the info you need</TD></TR></TABLE>

yep