how much does it cost to get your cylinder head hot tanked ported and polished usually? and getting it mic together... and how much is usually the whole harness for vtec wiring cost and to replace the sensors for the IM?

 

anyone?

 

Normally, porting and polishing, along with new valve job run between $750-$1000+ depending on where you go. If I were you, I would do some research as to who would perform the job.

 

itd be less if you bring them just the bare head... well id think it would be.... shop arround

 

send it to some smo with out a flow bench cheap, but who knows about the results..

find a good head guy ( don't laugh) and its expensive..but your get a better head..

(stop laughing now)