i hadnt posted a pic of my engine bay since i got my skunk2 intake manifold and my jg edelbrock header, so i thought i would. i also got a can of paint today and painted to upper part of my cold air(lower will be painted when i feel like taking the bumper off again), and my vavle cover. feel free to ask question bout anything. enjoy!.

Adam







also some of my new hood

 

looks good mang

 

mods? nice mounts what are they?

 

Nice job...

 

nice ride stunna, hehe

what's the deal w/your motor mounts? any reason i notice at least one has been replaced?

-Erik

 

PRob painted or sumthing

 

nice

 

mods?

 

both upper mounts have prothane inserts, and im looking for the front two mounts since mine are crap. and if i ever get around to it, i have the insert for the rear mount too.

as for mods, this is just copied from team-integra:
cold air intake, skunk2 catback, jg edelbrock 4-2-1 header, test pipe, power slot rotors, ebc pads, koni yellows, ground controls, skunk2 upper front control arms, Apex'i VAFC, MSD 6A box, MSD pro cap, MSD blaster ss coil, MSD 8.5mm superconductor plug wires, skunk2 short shifter and ****, suspension techniques rear sway bar/tie bar, ingalls rear camber kit, energy suspension hyper-flex bushings, performance continued: act 6-puck clutch, cluthmasters flywheel, redline mtf, skunk2 intake manifold, hondata intake manifold gasket.

16" black focal wheels wrapped in yokohama avs es100, carbon fiber hood, sparco hood pins, black housing corners

Adam

 

check out jimfab.com for engine mounts. I am in the market myself. I think i ripped on of mine... damn like looking engine bay. quite a few mods there. how do you like the msd set-up, notice much of a difference?

 

just thumbs to the sky

 

ill check that site out...and as for the msd, i didnt feel anything in the butt dyno after that, but im sure its not hurting anything. i wanna upgrade the box to a 6al, or better, just havnt had the money to start looking for one.

Adam

 

looks good!