I got the corner of my bumper cover scrunched.....I just want to straighten it out. Dont care about the cosmetics of it since I use it to go into construction sites everyday. I was goig to get a rubber mallet and start tapping it out. Any experiences?

 

yeah i used a big rubber hammer and hit out my dent before...on my accord..

i would fine an even spot where i can use to lay the bumper on and start hitting.......

 

I used a propane torch to warm the plastic from the inside before using a large broomstick and hammer to drive the dent out. It wasn't a perfect repair, but a huge improvement.

good luck