The combo had 1000 miles on them

$700 shipped




thanks,

chris

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by vha27 &raquo;</TD></TR><TR><TD CLASS="quote">The combo had 1000 miles on them

$700 shipped




thanks,

chris</TD></TR></TABLE>

links fixed for u

mike

 

thanks man, thought imagestation was down

 

would these work for a y7, im thinking no

 

i would say yes however the c/r would be different due to the dish od the piston and combustion chamber design of the y7

bore and pin diameter are the same

 

^

 

and again...

 

what compression?

 

cr is 10-10.5 :1 depending on resurfacing of block and/or head, as well as headgasket thickness used, according to endyn c/r is calculated respectively

(The compression ratio ranges given above were calculated using the bore diameters specified, stock strokes, stock combustion chamber volumes as given below, an 0.030" thick cylinder head gasket and piston-to-deck clearances of 0.020" and 0.000") check out http://www.theoldone.com for more info

 

Up for a friend!

 

Are these 74mm? Trying to see whether they will work in a z6 also.

 

75.5 mm, .020 overbore

 

what would the compression be with these pistons/rods in a dohc zc, also would they work?

 

not familiar with the zc, as long as the bore is the same i dont se why not, ud just have to gigure out the c/r

 

forgot to add, u will need to bore out your cylinders .020" to clean up the cylinders

 

pistons have been seperated, $375 shipped to your door

 

woo woo

 

cmon bump, bump, bump it up

 

still available?

 

still available

 

bump $350 shipped

 

bump

 

Would you be willing to split the combo up?

 

it has been split

 

Just a little FAQ. You can only use the y8 pistons with a y8 head. It will not work with the z6