Can anyone toss out the valve adjust specs for this car?

it's an F22 motor. Honda won't give me the specs.

Thanks in advance

 

I have alldata and mitchell on demand in my shop, but you have to wait until next week.

just post what you need and I'll get them for joo.
i think all you need is a hex key and screw driver(right??)

 

Just need the specs for intake/ exhaust clearances.

I believe it's .008 for intake and .011 exhaust but need varification.

 

on my 91, it says on a sticker on the underside of my hood... might be there for you. also, not sure if they're the same or not, but my 91 had .10 intake .12 exaust, at least thats what my chiltons said.

 

Yeah... I checked under the hood and there is no sticker there. It's my GF's car and she was in an accident awhile ago and I believe that the hood was replaced and the body shop didn't remove the stickers and put them on the new hood.

That is the first place I checked. But awhile ago I believe I looked in a service manual and the .008 and the .011 where what I remember.

Thanks for the help.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by desolate &raquo;</TD></TR><TR><TD CLASS="quote">on my 91, it says on a sticker on the underside of my hood... might be there for you. also, not sure if they're the same or not, but my 91 had .10 intake .12 exaust, at least thats what my chiltons said.</TD></TR></TABLE>

you forgot a couple zeros.

for the f22a1 its .010 for the intake and .012 on the exhaust side

 

Thanks for the numbers. That is all I needed to know.

 

yes, i did forget a few zeros. my apologies.