well, they didnt fit, i was told by a few people they would fit, but they are not even close, i figured since dsm 450's fit, why wouldnt these?? but i was wrong, unless there is something i am missing!!!! help if you can. they are accell 48lb;500cc injectors

 

My 550cc Venom injectors dropped right in with the stock Honda seals and stuff... I dunno what yo problem is.

 

dont use the eclipse seals.. use the honda seals

 

well, i think they might be like obd2 injectors or something though, the injectors have a little notch thing in them, and my clips dont have any where for it to go

 

cut the notch out and you should be cool

 

well, yea, i could do that, but, i tried putting the honda seal on the bottom, and on the top, and it will fit in there, but it isnt very tight as compared to the stock honda injectors, but iwas wondering if, when i torque down the bolts in the fuel rail, would that be good enough to seal it???

 

it's just like using regular dsm 450cc's...you have to "bore out" the inside of the honda seal so the injector will fit in there. If he was using the stock DSM rail, then they will fit into your rail. Also, you either have to cut out the little nub inside the injector plug, or buy some pigtails (the other plug with the wires) from accel or an autoparts store.

 

ok, i got them to fit pretty snug in there, hopefully they will hold up though, thank you for all of your help!!!!