I currently have a mild p&p head, n/a spec cam, cam gear, ti retainers, race springs, 10.5:1 pistons, obd1 ecu with n/a spec chip, clutch, 4.9 final gear.

I just got a JRSC and want to add a few more goodies to it.

First off, I think as long as I use a thicker head gasket the pistons will be ok...thoughts on that one?
Also plan on getting a chip intended for SC apps.

I see crower has a specific cam for F.I. sohc, so that is a possiblity, any other suggestions?

Fly wheel is pretty standard I think, so I'll go with a fidanza 7 pounder

Rods, can't seem to go wrong with Eagle.

Any other suggestions?

 

Eagles are a good rod, the ACT prolite is a nice flywheel, and I agree the Crower forced induction cam is a good choice.

For my nitrous setup I also used the 10.5:1 SRP pistons, Eagle rods, and I will probably use a ACT prolite flywheel, and Zex cam since the high exhaust lift is good for nitrous.

 

ohhh and the act is cheaper too

 

Recommended only Jun, expensive but worth it. If Jun have for your engine something I do not know. Wach Jun home page.