Hey all,

I am needing to add in a few additional sensors on my car with AEM v2. Sensors below:

1. E85 content sensor
2. fuel pressure sensor
3. water temperature sensor
4. wideband
5. IAT sensor
6. MAP sensor

So this leads me to three questions:

1. Can I just wire in the AEM water temp sensor to the factory water temp wire to where it sends a signal to my gauge cluster then to the ECU? or will that cause interference and an inaccurate reading to my ECU?

2. Can I wire in the AEM map sensor to my factory MAP sensor plug?

3. Can I wire in the AEM IAT sensor to the factory wires?

Will all these sensors need to be scaled inside AEM v2 for them to read accurately?

I understand all sensors have to be calibrated, but with the fuel pressure sensor is there a table I can follow that determines how much pressure I have VS voltage? Same with IAT, and Water temp.

thanks!

Bryson

 

Look in the wizards

If youre using all aem sensors then the wizard will automatically adjust them

Make sure you add in the pull up resistors appropriately

I think its needed for the fuel pressure or oil temp sensor

 

resisters? uh oh!

ok thank you!