So I have done a decent amount of research on installing the Jackson Racing FMU, but can't find exactly where I run the hoses to on the bottom of the FMU. I know where the top one goes. There are two outlets on the bottom. I know it is a novice question. This is my first time upgrading a car besides the basic intake-header-exhaust. I am including a picture of one in a car as well. So mainly what I want to know. Where does the outer outlet run too, and where does the inner outlet run too? Do I need to put a T fitting in anywhere?

Thanks!

 

I would avoid using it if you can and just get it tuned.

 

http://www.supercharger.com/graphics...ns/989-200.pdf

You'd be surprised what you find when you try to look.

 

I had looked at that link, I just couldn't figure it out. I actually found a really good thread that I re-read and re-read and finally got it. Once I find the thread I will post it again. I am using this set up temporarily. I have a friend in town who is teaching me to chip and tune an ECU. I am just doing this until then. I will have it tuned within a month. Just wanted to have some fun for now, and curious to experience the gains from a real tune.