CAMSHAFT - - F22A1/F22A4 - 2156cc(132") - 16 VALVE; SOHC 4; F.INJ - 85mm(3.346") - 95mm(3.74") - 1.9674/1.9685" - 1.8888/1.8890"
NOPI# 111+0701 is this a performance cam that will give my motor a thumping sound or is it a stock camshaft thanks?

 

Where did you find that part number? I can't seem to find anything.

 

go to the accord click on 1991 and go down it shows a camshaft. click there its a topline, nopi# 111+0701

 

I think stock is 1.5"-ish. I have never looked at the cam specs, so is the lift 'total' lift o cam lift?

 

Im not sure mike I haven't ordered cam yet,,, And it doesn't say..

 

Actually thinking of that with semi-beer-cleared head, that must be total lift on both counts.

 

Would it give it a better sound then its got now with a stock cam, or would it make any difference at all. And BEER IS GOOD!

 

Well, let me put this into perspective.
Back in the ancient '90s when I was in highschool*holds cain*.
I got sick of of the 'Malibu boyz' always rolling up on me in my 7cyl Fairmont.
So.
I bypassed the CC unit, and on my ole Fjord when I was at a stop, with the air bleed constant. This caused a most lumpy idle. Hell, even the single exhaust on my 5.0 sounded morbidly obese. It was very 'glug glug glug'. Course it performed like dick. But. It got rid of the 'Malibu Boyz' and I could ****-putt away my merry way.

So are you looking for sound or for performance?

Cause if you are looking for sound' remove your catalyst
Remove a plug wire
and let the good times roll.

 

trying to get both performance and sound.. if possible

 

Not sure of the "sound" you want.

Just me but an Accord is nover going to really "thump" at idle. I'd go for performace and let the "sound" be what it is - proper sizing of intake and exhaust to match the engine.

"Mike" - being a "high school product" of the 80's in the south. Well we never "pulled sound"....we made it with small/big block chevy and fords. Ever snapped an input shaft on a powerglide going into second ....that is hauling the mail.

 

85mm(3.346") - 95mm(3.74") - 1.9674/1.9685" - 1.8888/1.8890" is the specs
I really don't want to spend $200 on it if it isn't going to help the ultimate performance of the car. lol