FS: AEBS B18, Pauter Rods, Ross Pistons, NEW
Thread Starter
Honda-Tech Member
iTrader: (1)
Joined: Sep 2002
Posts: 177
Likes: 0
From: Fargo, ND, USA
FS: AEBS B18, Pauter Rods, Ross Pistons, NEW
Hey guys I am posting up a short block that was built by AEBS a few years back. It has never been ran since returning from them. I have not removed the tape off the top of the block even.
Build sheet reads
-AEBS T sleeves.
-AEBS O-ringed
-AEBS final bore and hone
-Pauter rods
-83mm Ross pistons 9:1
The motor after leaving there has never been ran. It has sit wrapped up on a shelf. It has been lubricated but if it was me I would take apart and lubricate everything again before running it but it is very clean and like I said has always been wrapped up.
Great motor good for 30 psi. Or just a reliable turbo LS/Vtec able to handle what ever you are going to throw at it.
asking $3250.00 Im willing to negotiate as id like to move this.
I am typing this up quick while at work so if I forgot anything or have any questions feel free to hit me up.
Build sheet reads
-AEBS T sleeves.
-AEBS O-ringed
-AEBS final bore and hone
-Pauter rods
-83mm Ross pistons 9:1
The motor after leaving there has never been ran. It has sit wrapped up on a shelf. It has been lubricated but if it was me I would take apart and lubricate everything again before running it but it is very clean and like I said has always been wrapped up.
Great motor good for 30 psi. Or just a reliable turbo LS/Vtec able to handle what ever you are going to throw at it.
asking $3250.00 Im willing to negotiate as id like to move this.
I am typing this up quick while at work so if I forgot anything or have any questions feel free to hit me up.
Last edited by 92HatchHybrid; Sep 10, 2014 at 04:36 AM.
Thread Starter
Honda-Tech Member
iTrader: (1)
Joined: Sep 2002
Posts: 177
Likes: 0
From: Fargo, ND, USA
Re: FS: AEBS B18, Pauter Rods, Ross Pistons, NEW
Sorry about that I edited it one time and then it didnt show up.
Id like 3250 or so. Im open to offers or cash and trades of some parts.
invoice on machining and labor to assemble alone was 3002.96
Id like 3250 or so. Im open to offers or cash and trades of some parts.
invoice on machining and labor to assemble alone was 3002.96
Thread
Thread Starter
Forum
Replies
Last Post
slowcar
Northwest (Sales)
1
Sep 18, 2006 05:51 AM
JDM turbo DC
Forced Induction
7
Nov 9, 2005 12:55 PM