I have noticed on a lot of integras the rear bumper has a non consistent gap like it droops a little especially on the sides is there a way to fix this or adjust it?

 

I think it might be the inner bumper support beam
http://www.team-integra.net/forum/11...cover-sag.html

Mine began to sag after I got tapped in the rear at an intersection. I was able to somewhat fix the sag by bending the beam, but I bought a new one I have yet to install.

 

Also new plastic clips that support the bumper to beam. Reusing them will cause bumper to sag. I installed new ones and helped alot.

 

Hmm lots of integras must have this problem...mine doesn't look anything as bad as that grey integra in that thread...just a little dip on the sides....so I have to take the rear cover off and look at the support?

 

Post pictures. It could be the the item noted above or you could solve your issues by just replacing the bumper hardware.

 

it could be, mine isn't as bad as the pictures either, just worse on the driver side than passenger side from bring tapped by a nissan frontier, my passenger side looks normal. It's easy to take the cover off.

Just post pics. Although even when I took mine apart, I couldn't really tell my beam was bent.