i have a 2000 integra and was wondering if anyone knows where i could get front and rear "H" badge and "honda" for the trunk.

 

try a 6th gen(EK) one afaik they share the same size as the DC integra, Honda in lettering idk any I've seen on ebay were not authentic the old accords had Honda on them but the holes are diff. I assuming you could just 3M tape them.

either way I'd also like to know since I just finished my jdm front thus need H badges

 

wouldn't you use the red h badges instead of the silver ones since you have the jdm front?

 

Too played out I like a clean OEM stock look, but i'll probably end up buying red ones just want to avoid spending $200 on something kids can pry off.

 

how did your jdm conversion go? im about to buy a jdm type r front end for 1200$ and i hope i dont f*ck it up.

 

Really good!(see my build thread) I've never done body work but I followed this DIY http://www.team-integra.net/forum/19...icle-help.html on TI and it was very helpful. Only thing I can say is align it to the nearest cm then weld it or you can bolt it via drill holes and bolts not recommended, as there will always be some flex with bolts vs bead welds.


but $1.2K that's really steep are you getting OEM Hid's with it ? otherwise they run from $400(no rad support) to $800-900 from importers around here.