1996 Integra GSR intermediate shaft stuck inside of a 1991 Y1 transmission about a quarter of an inch. Any ideas how to get it out?

Been prying the **** out of it for half an hour with 4 different guys trying.... Sprayed some penetrating greese to try and make it easier, hammered the **** out of it with a some wood and a hammer, pretty much been completely givin her **** and it hasn't budged.

I also suspect my transmission is toast now and someone owes me a tranny to. Opinions?

 

Sounds like your stuck on the retaining clip at the end of the shaft. Use more leverage. Long bar little force is alot better than little bar lots of force. I use my pickle fork and have never had a problem.

 

Just replaced clutch in my EM1, used a hardwood dowel on each side of the spider shaft and tapped with a deadblow hammer. It came right out. The car had 171k mi and could not pry it out. Good luck.
Regards
Dave

 

Hammer on the passenger side of the shaft towards the driver side. It'll pop right out