Hello I am a couple of a months new to honda tech & Honda game the potential of any engine & interchangeability grabbed me so I grabbed the eg 1995 ex coupe all hacked up & in horrible condition due to previous owner, I've purchased things for her to get her looking brand new (I'll put a list at the end) I'm just trying to get the shell ready for a ls or vtec single cam swap before it snows in Mass for future plans koni/gc coil over kit full lca subframe set up(still deciding) H23 Vtec H2B Ctr tranny the block is gonna be sleeved with darton mid sleeves & hot tank for whole motor don't know what pistons yet skunk two pro 1 cams skunk 2 valve springs & retainers k2h rcc intake mani (gonna get polished & ported) don't know what throttle body yet & a good tune I'm trying to keep it a for street car as it will be my daily driver since I am building this with my own money It's gonna be a slow a build but worth to check on its not just hobby for me but a passion I love cars & everything about them gonna own my own shop this is just the start
(PARTS LIST)
BACK BUMPER 30$
SHIFTER CONSOLE?
ARM REST DELETE?
FRONT END 300$
SHIFTER **** 5$
REAR SEAT 70$
RACING SEAT 300$
PASSENGER DOOR 120$ DELIVERED
I APPRECIATE EVERY WHO READ COMMENTS LEAVES FEED BACK & OPINIONS MUCH LOVE
:.. So I was finally ably to take some pictures of the parts that where purchased & serious rust in engine bay being worked on hopefully I'll be able to get some work done this week thanks for watching

 

I'll take & post pictures of things hiding for the car in basement after work tomorrow or before I go

 

Quite an undertaking for your first build; I admire your dedication. Good luck!

 

Good luck , take your time and do it right the first time.

 

first of all, thanks for putting this in the appropriate section! instead of 92-00 tech.

secondly, good luck with build..

 

Thanks everyone

 

have fun

 

Fix the rust first and foremost! if you dont, itll only get worse!

Good luck on your first build!

 

Thanks & I know that's why I haven't put the car back together yet I'll post a picture of some rust in the engine bay that was holding me back ridiculously tomorrow & already have both rear quarters just needed to be cut to fit I've been researching for a while a now hopefully in 2 months it'll Be done with the ls or single cam

 

These are pictures of rust in engine bay purple peice I'm holding was cut out due to rust replacement is there in the picture black peice of metal with blue writing cost me 100 from junk yard need to get this back on so I can put the front end back & buy a suspension

 

Wow, that looks like a lot of work! Good luck!

 

Thanks I have faith this will get done, after the h23vtec h2b maybe a f20b turbo F2B