Edelbrock/GT28RS on a D16A6
Thread Starter
Good, Bad…I'm the one with the gun
Joined: Jul 2002
Posts: 5,241
Likes: 2
From: Trapped in time, Surrounded by evil, Low on gas
Edelbrock/GT28RS on a D16A6
looking at the turbo assembly i realised that the oil dipstick will not fit through the exhaust manifold. does anyone have any pointers as how to address this issue?
Who is Mr Robot?
iTrader: (2)
Joined: Jul 2004
Posts: 21,474
Likes: 10
From: ATL - Where the Pimps and Players dwell
Re: Edelbrock/GT28RS on a D16A6
Another way is to put a screwdriver in the end of the tube, heat the tube with a propane torch and slowly bend it. I've creased/cracked a few dipstick tubes being over zealous with the dead blow hammer lol. My sr20 dipstick tube cracked in half at the base when I moved it slightly to clear the compressor housing
Thread Starter
Good, Bad…I'm the one with the gun
Joined: Jul 2002
Posts: 5,241
Likes: 2
From: Trapped in time, Surrounded by evil, Low on gas
Re: Edelbrock/GT28RS on a D16A6
cool it looks like it CAN fit between the runners. thanks for the advise and the photo!
Thread
Thread Starter
Forum
Replies
Last Post