97 DX D16A auto. Full skunk 2 coilovers, skunk 2 upper control arms, EX arm rest, SIR front end and rear bumper, blox lower control arms, ebay subframe brace, works lower tie bar, rota CR1 wheels (work knock-offs) wrapped in 195-50-15s. Also, tanabe full exhaust. Next mods are SIR interior with SIR wing and rear OEM fog light, or domani trunk lid- don't know which would look better. Looking for comments!

p.s. first 2 pics are before i did the SIR swap

 

Looks great, now find the proper motor for it

 

Looks like your sidemarkers are wired wrong, unless that was intentional. Love the SIR bumpers

 

You should remove your bumpers and pound them out so they fit flush on the fenders and get new hardware. Those gaps make the car look cheap and run-down.

https://honda-tech.com/forums/honda-civic-del-sol-1992-2000-1/%5Bfaq%5D-how-get-your-92-95-bumper-fit-flush-your-fenders-%2Apics%2A-1751772/

 

I used this method on my car years ago and it works wonders. I'd recommend using a locking nut though since a standard nut will likely come loose over time.

 

I'm using a bolt with 2 washers, a lock washer, and a nut for mine. It's been great so far, but I do remove my front bumper at least twice a month lately.

 

thanks for that idea

 

not feeling the wheel/tire setup, but SIR <3

 

^^ I agree. I like everything but the wheels.

 

not feeling the wheels.

 

x3

 

i had mugen m7 wheels. i had to sell them i need money for my wife car. Thats when i picked these up for 800 for ebay and i had the tires in garge.
i would like to swap them for something else like bbs rs or mugen m7 wheels again.

 

how much did those sir bumpers cost?

 

too much meat on the wheels...and wheels look small...

 

i paid 850 for both bupmers. i want to buy 165 45 15 tires for the rims or some others wheels. im a wheel *****

 

Car looks good!

Lower it a tad more with a smaller tire and the fitment would look great IMO.

 

says he's a "wheel *****," but buys rotas. can't explain that. OP- car looks dumb.