Ok so I have the adjuster adjusted all thee way down to wear the clutch arm is comming up. It still won't go into gear without wanting to pull

 

Did you check to make sure the clutch pedal didn't break?

 

It's stiff like it should be

 

has the cable stretched. is this you first time adjusting it?

 

I did a motor swap . I put a jack under the arm to adjust it all the way down. It got super stiff . I replaced the through out bearing too. This clutch was weird putting on the fly wheel. It butted all the way up but there was still a gap between the flanges and the fly wheel where it bolts down I tightens it down till they were flush , could that be it? It's a universal clutch too. D15 and 16. It's a sohc Zc with a d15 tranny

 

I just took the cable off and adjusted it to just take the play out. Still nothin

 

go over this with me again, cause to be honest im having a hard time understanding.
but there def shouldnt be any play in your clutch setup, can you move the clutch arm by putting a jack underneath it and jacking up.