Im in the process of hooking up my boost controller and im alittle confused on the routing of the lines. Is everything hooked up correctly in the picture i have taken? Then do i just put another tee fitting on that same line going to the turbo compressor housing? Any help would be greatly appreciated! Thank you.

 

Maybe once we get a picture. Your boost gauge should go off the intake mannifold and not the compressor housing.

 

http://www.xenocron.com/install/PWM-...00-neptune.htm

Here you go sir.

 

What i need to know is which wire goes to ECU(A11) and which wire goes to fused 12V power source. I bought my MAC solenoid used and I can not seem to tell the difference in wires as they do not appear to be marked.

 

I believe it doesnt matter which wire goes to A11 or 12v

 

I know the boost gauge is suppose to go off the manifold. My question is do i cut the line that has a tee fitting in it already and put another tee fitting in so i can run a line to the compressor housing? Sorry if i wasnt clear enough

 

The line going off the picture on the bottom right hand corner is going to my intake manifold. Can i just put that line to the compressor housing of the turbo instead?