Alright, so i have a b20 block with b16 head that was recently fully rebuilt with all stock internals. I want to boost it and make about 300hp. What can i do to make that power and be safe

 

Piece together a good turbo setup and dyno/street tune.

 

should i build it before i turbo it though? just to be safe? Because i want to run about 10-14 pound of boost. So i was thinking maybe stronger rods, bearings, thrustwashers, and 9:1 compression pistons? Cuz i don't want to put in a nice turbo and later down the road have problems with the motor

 

That's common sense. Build it right or don't do it at all.

 

would not be a bad idea to look into a block guard

 

if you don't know something please dont give advice blockguars are sh*t they fail a lot

10-14psi on what turbo dont turbo your car because you do not know what youre talking about yourself a stock b-series can handle 300wheel but thats pushing the motor

 

I never said it could't handle it, it's just a matter of how long it can handle it. I'd rather be safe than sorry

 

depends on your tune but you saying im thinking of running 10-14psi is just an instant that shows that you have done no reaserch what so ever

10-14psi on a K03-S stock audi turbo is diffrent than a GT35R Turbo just saying do some reaserch

 

Remind me to never read your posts! LOL

 

If it was just rebuilt with stock internals why are you worried about rebuilding it again? If you haven't already get some ARP rod bolts.

What mods do you already have, and what kind of power are you currently putting down, are you tuned?

 

Its cool broe..you dont have to remind me that your an idiot and you dont know ****. Sooo you can stfu now
THANKS!!

 

I've never meant face palm as much as I do right now...

 

can you safely get 300 whp out of a stock engine ITR by turboing?

 

lol you seriously are a imbecil

 

LOL Troll much?