I'm looking for a 16 in deep dish wheel. what size is good 7 or 7.5?? what offset?? I'm not looking to stretch the tires(at least not where its unsafe), have the wheel sticking out like crazy. A little bit of camber is ok but not huge amount of camber. wouldn't mind a big wheel lip.. I'm planning to roll not pull the fenders cause i want the wheel to be flush with the fender.. I know for what I'm asking I'm not going to get a really low offset or a really big wheel lip.. I was also thinking of putting 205/45 or 215/45.. pics would be good

btw the car is dropped around 2 inches

 

To be honest, you could run a 15x8 +35 on the car with 225/50/15's when you roll the fenders/quarter panels, and run some negative camber.

As for stretching tires, its against the rules in this forum for obvious safety risks.

 

https://honda-tech.com/forums/honda-acura-28/share-your-stance-guide-achieving-ideal-setup-2904182/

A little searching goes a long way.

 

wow I thought 215 was the max. thanx ill keep that size in mind.. as far as stretching the tires, I didn't know if any type of stretch was safe.. I guess not... any Idea on 16's offset??

yes it does, but that thread has stretched tires and too much camber ... I did look at all those pages and didn't find what I was looking for. Unless I missed something in one of those pages... Ill look again..

 

It'd be roughly the same, but finding tires will be far more difficult.