Hi guys,

I wasn't sure where to post this up as I'm not too used to HT yet.

I have a set of near new Injector Dynamics ID1000s for a B series. My question is, is it possible to manipulate the b series ID1000s to fit a k series rail?


Am I right in thinking that the only difference on the id1000s for K and B motors is the 'top hat'?


Thanx in advance.

 

Not trying to be a smartass but If the person that told you that it could be done shouldn't they have been able to tell you how?

http://www.k20a.org/forum/showthread.php?t=37746

 

Fair comment lol It was just a quick chat a friend had with a tuning company. I think they were really intent on him paying them to do the job so they didn't tell him how to.

thanks for the link

 

i believe all ID's are the same really just different top hats and what not

 

That's what I thought ^^^ Thanks for the comments.