shot some clear yesterday and got some runs when can i sand them out and clear again?

 

How bad are the runs? Can you sand and buff? They make a file for knocking down 90% of the runs before you sand with 1000 grit, 1500 grit, 2000 grit and buff. I have seen people use easy sanding bondo and apply over run. sand aggressive until bondo is almost gone then switch to 1200 grit sandpaper.
I would wait 48 - 72 hours unless you used snap dry.

Thought this was a cool tip when I saw it.
http://www.custompaintforum.com/foru...un-Removal-Tip

 

sometimes you can sand out a run without re-clearing. just keep working at it until the wave is gone, if you sand or rub through block it out and re-clear.

 

the runs are pretty bad wasnt paying attention and my wife was rushing me so i planned on sanding out runs and re clearing

 

^^^^^ Good answer

 

800-1000grit and reclear

 

Razor blade or small file, then sand and buff. That spot putty trick works very well also.

 

k ima clear the car and let it cure then ill take care of the runs that will give the small parts w runs 4 days of curing