so i cant figure out how to install the extended lug studs i got for my ef wagon heres where i got to so far.


ive tried beating on the back of it with a mini sludge and nothing happens. i dont want to keep going that route because im afraid i might damage it.. am i missing sometihng?
this is really pissing me off because ive done almost everything else to this car but i cant figure out how to take the damn hubs off . and ive been sick so its more stressful and annooying than not being sick and working on it.

any input would be helpful thanks

 

The hubs have to be pressed out..

 

in for how you figure it out.

 

And for a bonus, you will have to install new wheel bearings when you put it back together.

 

And then everything have to press in.

 

might as well throw in new ball joints while you're in there too

 

yeahhhh.. thats how its looking i guess i was right haha i didnt want to be right but i guess i should get used to always being right about everything always. thanks!

 

As am I.

Here is my write-up if you are too cheap to take it to a shop...

https://honda-tech.com/forums/honda-crx-ef-civic-1988-1991-3/write-up-diy-front-wheel-bearing-replacement-2685054/