so i wanted some help on a motor im building very soon.....i just bought a b18b1 block recently wanted to know if a 220+ hp motor was posible to build on stock sleves......and how much are we talking....i make good money but this is going to be slow but stedy build.....

what i have thought up soo far.

b18b1 block, honed & cleaned
weisco 12.5:1 pistons
eagle rods
arp rod bolts
acl race bearings
seals...oem?
micro polish crank

think im wanting a b16 head

port, polish & valve job
mabye crower springs & cams?

wanted to know what i could do with something along these lines, or if this would even be a good build.....i know motors somewhat and not a complete noob around hondas but want to be happy with this. thanks in advance

 

Well i know that you'd be in the 200 whp range and maybe i'm exaggerating but around there. I have seen b20 vtec's in that range with skunk2 pro2's and 11.5:1 compression. just depends on the tune also so you should be good.

 

Gsr or ITR head, yes have it ported, supertech valvetrain and pro 1 skunk2 cams, your golden..