I have a rsx base model that I would like to make a little mods but I need help on what to do.? Im thinking of getting a k20a2 head or a k24 head with a k-pro in it what do you guys think or what do you guys recommend?

 

nice... if you get the k20a2 head your gonna need to swap out your intake manifold for an ep3 manifold or type-s and its not recommended to rev that combo to high because the A3 bottom end isn't built to handle it. What k24 head we talking about here?

 

I'm sorry but I laughed.... you first said you would like to make "little mods"

then you go and start listing you want to do a head swap?! lol What's little about that.


The A3 is worthless in my opinion (no offense to all) and the rods are definitely a weak point. If you are talking about a head swap you should just look into swapping the entire engine out to a k20a2 and kpro. Either way kpro is an obvious mod when talking about any power or performance gains.

 

K-PRO FTW!

 

Well that's a little to what I did to my other cars in the pass and if I'm going to get k20a2 might as well go type r but I was just looking on spending no more then 3k

 

my honest opinion don't be a JDM fan boy.. the k20a type-r engine is nothing to much more special than the type-s engine. The k20z1 is practically a type-r engine. For less than 3k you can drop a k24a2 full engine in there and it would be a whole NEW car... you'd be killing people.

 

Look at this guys build

http://forums.clubrsx.com/showthread.php?t=775362

 

where can I do a k20a2 swap for less than 3000$? So far engine and tranny alone is almost 3000$

 

Well, that post is from 2011, you know. I do agree that there's no way you'll see the price that he's quoting on a full swap these days.