So ive gotten a new camshaftseal from honda and used honda bond and it leaked again after a few months so iw as wondering which one should i get since ive been recommended a pwjdm seal or a Skunk 2 i was wondering which one is better quality usually i would not purchuse from PWJDM cause of their shipping prices but its free shipping or should i get skunk2 im not doing this for the bling Factor but since it is not that expensive i'll order one of these

this is for the B18B so the honest question is which manufacturer has better quality I've read both have good quality

 

I would think any other the aftermarket multi seal cam plugs would work well. That being said, look for best pricing

 

yea thats what i did i actually reaserchd a little bit more and decided to go with the PWJDM seal cause it cost 17.99 because of the SEMA sale i got 2 bucks off and free shipping so i got that one

 

18 bucks and free shipping sounds like a good deal, plus it is aluminum.

 

Yea it is theres this other site that's sellibg them for 17 bucks but 12 dollar shipping lol

 

I bet the Honda one is not cheap anyway for plastic.

By the way what is the easy way to get it on?

 

Same seal different logo

 

i used the ebay aluminum one a few times and worked just fine

 

to replace the seal? take off the valvecover take off the two bolts that are ontop of the seal bracket pop it out put some rtv/hondabond on that area put the new seal in torque the new seal down torque valvecover down done in 10 minutes

 

so you gonna but my ***** for calling it a cam seal, when u wrote a goddam thread about a "camseal"