Got around $800 to spend on a JDM or OBD1 GSR block.

Needs to be setup similar to what I'm listing below.

- JDM or OBD1 GSR block ONLY!
- Wiseco, JE, SRP or CP low compression pistons
- Eagle or Manley H beam rods
- ACL race bearings or equivalent
- ARP GSR head studs or equivalent
- Recently honed, decked and hot tanked (less than 2500 miles *need receipts if pics don't look as if work was done*)

I'm looking to slap this block on my head and be done, so I don't need to inherit any problem blocks that smoke, leak, spun a bearing, need to be resleeved or need to be rehoned.

If you have something that qualifies for what I listed, PM or email me at integracosmin at gmail dot com.

 

if you decide to build your own block, I have BNIB eagle rods for GSR.