I building a bottom end with stck crank eagle rods and probe forged pistons. I also got a crower top end I thinking about using as well but the cams are all motor cams how would tjey do with a turbo and how many pounds of boost can I run on a daily basis safely with no problems. Or is tjwre anything else I need to put in my motor while I b7ilding it to make it a little stronger

 

Any help ????

 

What power r u trying to make?

Your Budget?

 

I already got the turbo and stuff. All I like is buying the bearings and rings and it ready to be put togethwr. I was wanting to run 8 pSI daily driver. Do you think my bottom end will be alright or do I need to add to it and also stage 2 crower all motor Cams be alright or should I swap em or buy turbo Cams.

 

wow spelling and caps,8psi on what turbo?can range quite abit

 

T3 t4

 

Need some help on turbo build

 

lol

 

so t3 t4 huh... sounds like a turbo out of a 911 lol

 

damn bro double check ur spelling its hard to understand what r u trying to say. 8psi on ur set up is ok. yes, u can use N/A cams on a turbo set up if that is what ur asking.

 

Viera thanks for the help I posting off my Droid so sometimes it don't spell worth anything so do you think the setup I will be building will be alright my pistons are 81.5 mm. The spring in my turbo setup is 10 pounds is thatsafe enough and how you think my all motor Cams will do in that motor being turbo charged.

 

what size t3/t4? and yes the allmotor cams will be fine

 

I not real sure I bought it from a friend two days ago. Would I need head bolts or factory be alright to use with head and with Cams and turbo

 

Bump for help. What would be horsepower with my set up on ten pounds of boost

 

With my set up

57mm trim
stock block
stock head
11psi

220-240ish whp

so with some cams and other goodies expect a bit more

 

I going with a little bigger bore as well do Yall think I need arp head bolts as well or will it be alright with stock ones on it