Exhaust a bit too loud...
Thread Starter
New User
Joined: Oct 2001
Posts: 3,506
Likes: 0
From: USA
Exhaust a bit too loud...
Here's my setup: High flow cat, 2.5'' crushbent (mandrel wasn't available...and i didn't wanna run open header
) piping, and a thermal straight thru muffler. Low rpms...very deep tone. Actually once I shift a bit past 3Krpm...gets a tad raspy. When vtec hits...raspy galore. It has a sweet sound to it...but i think it'll eventually get the attention of cops. Other than that...my car is dead stock looking.
Here's the question: If I get an ITR muffler...will that quiet it down? Would I lose considerable power or not enough to notice?
-Rod
) piping, and a thermal straight thru muffler. Low rpms...very deep tone. Actually once I shift a bit past 3Krpm...gets a tad raspy. When vtec hits...raspy galore. It has a sweet sound to it...but i think it'll eventually get the attention of cops. Other than that...my car is dead stock looking.Here's the question: If I get an ITR muffler...will that quiet it down? Would I lose considerable power or not enough to notice?
-Rod
Honda-Tech Member
Joined: Sep 2001
Posts: 12,176
Likes: 2
From: Tucson, AZ
Re: Exhaust a bit too loud... (RK)
have a resonator welded in
and just so you know a crushbent will hurt your airflow.
it was once said a 3" crushbend exhaust will flow like a 2.5inch mandrel.
and just so you know a crushbent will hurt your airflow.
it was once said a 3" crushbend exhaust will flow like a 2.5inch mandrel.
Thread
Thread Starter
Forum
Replies
Last Post
frostcivic
Honda Civic / Del Sol (1992 - 2000)
7
Jul 21, 2004 10:53 AM