new guy, northern california
hey guys, my name is mike. im from northern california. im new to honda tech but not so new to hondas, i currently drive a 96 gsr-l. my father bought the car new in 96 and gave it to my sister in georgia in 99 or 2000. i recently flew out there and picked it up for free from her and drove it back. the car was awesome the whole way, 34 mpg and didnt burn a drop of oil over the full 3000 miles. the clearcoat is gone, but the body is straight as an arrow and the interior is pretty much flawless. milano red with black leather.
I recently put a couple bucks into it and plan on putting more into it soon.
current mods
tokico illuminas with eibach pro kit
konig heliums with 205/50/15 azenis rt-615's
old school comptech sway bars (installed when my dad bought the car new)
redid the whole front end, tie rods, ball joints, end links, etc
spc camber kit (rear)
skunk2 camber kit (front)
engine:
mild port and polish (tem machine NAPA) .020 removed from head
skunk2 pro manifold
blox 68mm throttle bady
skunk2 tuner stg 2 cams
skunk2 pro ti retainers and dual springs
new oil rail and hardware
cometic .031 head gasket
arp head studs
hytech replica header with custom mount for stock heat shield (big tube)
2 3/4 stainless cat back exhaust with vibrant flatblack muffler (built by me)
3 inch hollowed catco cat
3 inch cold air intake (fabbed by me)
rc 450cc injectors (12 ohm)
bdl fuelrail
hondata s300 in p28. converyted to manual and hondata install by me
boomsland obd2a-obd1 jumper
no dyno numbers yet but ill be going to midnight performance in sac. later this week
I recently put a couple bucks into it and plan on putting more into it soon.
current mods
tokico illuminas with eibach pro kit
konig heliums with 205/50/15 azenis rt-615's
old school comptech sway bars (installed when my dad bought the car new)
redid the whole front end, tie rods, ball joints, end links, etc
spc camber kit (rear)
skunk2 camber kit (front)
engine:
mild port and polish (tem machine NAPA) .020 removed from head
skunk2 pro manifold
blox 68mm throttle bady
skunk2 tuner stg 2 cams
skunk2 pro ti retainers and dual springs
new oil rail and hardware
cometic .031 head gasket
arp head studs
hytech replica header with custom mount for stock heat shield (big tube)
2 3/4 stainless cat back exhaust with vibrant flatblack muffler (built by me)
3 inch hollowed catco cat
3 inch cold air intake (fabbed by me)
rc 450cc injectors (12 ohm)
bdl fuelrail
hondata s300 in p28. converyted to manual and hondata install by me
boomsland obd2a-obd1 jumper
no dyno numbers yet but ill be going to midnight performance in sac. later this week
i actually only have maybe 600 bucks into the whole setup.
i bought a eagle 95mm stroker kit for 400 bucks off a guy on craigslist and traded the whole setup for pretty much everything i have listed
i bought a eagle 95mm stroker kit for 400 bucks off a guy on craigslist and traded the whole setup for pretty much everything i have listed
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post








