81mm StockSleeves 67mm turbo EG
Thread Starter
Honda-Tech Member
Joined: Oct 2009
Posts: 143
Likes: 0
81mm StockSleeves 67mm turbo EG
This car is being setup for the "true street class" this year. Bottom end is being built this month but in the meantime we decided to test it on the stock sleeves 81mm block, cp 9.1 pistons & eagle rods to get it dialed in a little bit....not bad for a simple setup... in the meantime.
GSR 81mm block Stock Sleeves
CP 9:1 pistons
Eagle rods
Stock unported head, ITR Cams
Skunk2 Valvetrain
Stock GSR Tranny
Precision 67 turbo (non BB)
1000cc Injectors
Walbro 255 intank with stock fuel lines (for now)
Hondata S300
http://www.youtube.com/watch?v=clrOjqhEYA4
GSR 81mm block Stock Sleeves
CP 9:1 pistons
Eagle rods
Stock unported head, ITR Cams
Skunk2 Valvetrain
Stock GSR Tranny
Precision 67 turbo (non BB)
1000cc Injectors
Walbro 255 intank with stock fuel lines (for now)
Hondata S300
http://www.youtube.com/watch?v=clrOjqhEYA4
Thread Starter
Honda-Tech Member
Joined: Oct 2009
Posts: 143
Likes: 0
Re: 81mm StockSleeves 67mm turbo EG
Well, it currently runs @ 25psi (620hp)....but on the dyno while the boost pwm duty was being set it actually hold a pull @ 29psi, it made more that what a stock sleeve block should make and i just refuse to run it at that power level....LOL. We'll wait for the new block and go for it.
Last edited by CMB-TUNING; Mar 18, 2010 at 07:33 PM.
Trending Topics
Honda-Tech Member
Joined: Jun 2002
Posts: 2,105
Likes: 0
From: Florida, us
Re: 81mm StockSleeves 67mm turbo EG
Well, it currently runs @ 25psi (620hp)....but on the dyno while the boost pwm duty was being set it actually hold a pull @ 29psi, it made more that what a stock sleeve block should make and i just refuse to run it at that power level....LOL. We'll wait for the new block and go for it.
Honda-Tech Member
Joined: Feb 2008
Posts: 2,087
Likes: 1
From: That 24K, VA, USA
Re: 81mm StockSleeves 67mm turbo EG
Im still surprised that the stock bore cylinders were straight enough that he could use 81mm pistons. Must have been a fairly new block with low miles on it. Most all of the ones I have seen are not straight enough anymore to use 81mm pistons....
Thread Starter
Honda-Tech Member
Joined: Oct 2009
Posts: 143
Likes: 0
Re: 81mm StockSleeves 67mm turbo EG
On the 10.2 pass the 60' wasnt that good (1.66).
It suck that on the best run of the night (1.60 60') the intercooler piping came off in 3rd gear:
http://www.youtube.com/watch?v=b9z7u3BRbUA
It suck that on the best run of the night (1.60 60') the intercooler piping came off in 3rd gear:
http://www.youtube.com/watch?v=b9z7u3BRbUA
