I have searched for the following and have yet to find... well useful information on these cams. My question is for those who are or have ran Buddy club spec 3 plus cams and p1 cam gears on their gsr motor. I don't have access to a degree wheel... and i was wondering what were your degrees for your cam gears at TDC. I know it varies if the motor has been milled or not. So we'll just say everything is stock as far as alignment. Any information would help.

 

You install those cams at 0-0 on the cam gears and then tune them on the dyno. No need for a degree wheel.

 

Thats what i what i did but i just wanted to make sure i could have it at TDC before i go for a tune.