I unfortunately let myself get distracted and cut the inside of the valve cover. I was in the process of cutting it for adjustable cam gears. Am I now going to have to buy a new valve cover? Think when the gasket seats down in there some extra rtv would do the trick? Sorry for the pic quality.










[Modified by ImprtTuner88, 2:58 PM 8/30/2002]

 

JB weld or a little more RTV will be more then fine

 

thanks, hope so! .............I was like, dammit John, pay attention! damn its friday, I need a

 

you should be just fine with a little honda bond

 

YEAH, Friday, time to have some

oh, and like he said, some JB weld or rtv should do the trick.

 

haha, you goof! must say though, what did you use to cut? abusing NC appropriated shop equipment again?


[Modified by dogpile5, 3:33 PM 8/30/2002]

 

I used a hacksaw where I messed up and a dremel with a cutting disc on the rest..........................and yeah, one nice thing about my job, all the damn tools I can use! YEAH!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

I'd imagine you'll be fine...the gasket should take care of that.

-ryan

 

Nice move there slick... I would use the Honda bond or similar material. I think it will be just fine. If not, we will just switch it with Justin when he is not looking...


Jason

 

jeremy is just gonna go pull one of his spares and swap it with mine, and I get to start over! thank goodness for jeremy!

 

do it and you can forget about any updates to your websites...