Well last night I was taking the oil jet out of my a6 block and tugged and tugged and my screw snapped off inside the block. Poop! Does anyone have any ideas on getting that thing out? I'll post pics in a few hours.

 

Yeah get an extractor tool, use the appropriate size bit, drill a hole, then put the extractor in, pull it out. It is extremely simple...

 

small needle nose pliers

 

Considering most are flush with the block? Good one... stop representing Warsaw correctly.

 

drill out hole, and use a bigger screw? it shouldn't be that hard to take out... i barely tapped a self tapping screw into my oil jet and the thing pulled right out

 

What?



screw snapped of i doubt its flush, small needle nose should grab it

 

no it did snap flush I'm gonna try to jb weld a bolt to it and see if that works

 

well thats not the worst idea i've ever.. i reckon it just might work! lol

 

haha well see boys just have to wait awhile for it too set up ya know

 

I always use 1in 2x4 wood screws and it comes out every time...
and can never break