my dizzi went bad right so i got a brand new one, but here it is i forgot to mark where the rotor was when i took the off one off, stupid right, rushing get you no where, and now im afraid to put the new one in because if i put it in wrong i dont want to mess up the timing, i figure i have a 50/50 chance of getting it right because theres only two ways to it will fit in but i thought id see if anyone could help me on the easiest way to figure this out, and i know there a notch and timing marks by the pulleys but i can barely see them, any help would be great.

 

get a timing light and paint your old lines in crank pulle. As for the timing set the dizzy at number one and set the pulley at tdc install dizzy and use your timing light.

 

sorry ppl, i realized right after i posted this that the teeth on the dist, that go into the cams are off-set to one side, so it only goes in one way, hope this may help someone else at some point...