I will be dropping my gsr motor in within the next year when its built and i was wondering if a 2000 em1 engine harness will clip into the drivers side harness that then runs in into the cabin area? Or will i have to get the whole dash harness out of an em1. My friends gf picked up this harness and it doesnt work on her crx and i was wonder if it would would on my 97 dx hatch harness since shes selling it for $100.

 

someone has to know this answer

 

anyone?

 

yeah you should be good there is gonna be some other things you might need to wire in though.

 

id say just try it? not hard to undo clip and try the other harness.

 

if your going to run the si harness you will need an obd2a to obd2b conversion harness but is pnp.

 

but the si engine harness will clip into my stock dx harness that runs into the cabin on the drivers side i dont remember how many pins it is on the connector. Yea im just trying to see if it will work before i make her drive an hr both ways so she deoesnt go out of her way just to save her some time if it doesnt.

 

You need the interior harness as well.