not sure if this belongs in tech, FI, or here, but its ecu based so here it goes:
how do i set up a PWM solenoid? havent found any tech articles for it, and i do mean full set up. from whatever part of the turbo it connects to to the solenoid to the ecu. any help (especially diagrams) would be great, thx

 

Which solenoid are you using? If it is the Mac valve, port 1 should go to the boost source and the bottom of the gate, and port 2 goes to the top of the gate, while port 3 is open or has the muffler/filter thing on it. One wire goes to +12v ignition power, the other wire goes to pin A11. That is just the info off the top of my head, sorry, I dont feel like drawing a diagram..

 

yeah sorry its the MAC valve from xenocron

great info thx. both wires look the same (either that or im going color blind) so i take it it doesnt matter which one goes where?

 

There is no continuity....

You can find a plumbing & wiring diagram on http://www.phearable.net/tech

Your ecu must have PWM control components in it to control a11.

 

sweet, checked out your website earlier looking for a diagram but i guess i missed it. thanks
#3 says its an atmospheric filter...do i hook anything up to that or do i just leave the space open?

 

Use a brass cone filter.

 

anywhere in particular that sells those?