I was wondering if an exhaust form a DC would fit an EF if I got custom hangers and an adjustable/custom test pipe. I like the exhaust being on the right side vs the left. I don't want a custom exhaust, but I do have an Apexi N1, this is the reason for the question.

 

hmmm i bet if you modified it you can

 

modified it like how?

 

to where it fit. LOL. Might have to cut/add in places, change some bends etc. I wouldnt waste my time, just buy a Greddy SP2 or another exhaust that exits that side and say the hell with it.

 

lol, yeah I don't want some hacked up exhaust. I'll figure something else out
Thanks

 

Ok so I thought this was resolved... well i lied. I was taking of the CRX, Honda, and HF stickers on the rear(along with some Barry University thing from 1996 lol) and decided for some s+g to see how close the n1 would be to fitting. Well the bends are the same it's just too long towrds the Headers. It would leave me with about a 5-6 in. gap between the header and exhaust pipe. I would think I could just get a custom "Test pipe" made that fits these specs along with custom hangers. Then the problem becomes... Right side exit + left side cutout = fail any remedy for this?