here is a picture of my engine bay, my iat sensor is in the silicone coupler right before my intake manifold, if you look you can see it. anyway i have to be leaking boost from that hole because its not air tight, so what options do i have?

 

I have the solution on my site, but last time I said it, the post got deleted, so I won't mention it, lol.. Basically, have a fitting welded onto the charge pipe that holds the IAT..

 

yea ive heard that before actually. my IAT isnt screw in tho, would i have to buy one of another car?

 

Just use some silicone to put around the sensor to make it air tight. My buddy just drilled a hole in his tubing and put some clear silicone around it so it doesn't leak.

 

yea .. i tried that but it was like a 5 minute thing and i ended up not getting the silicone around the whole thing and it ended up cracking anyway, thats what i'm gunna do when i get some time

 

maybe before the turbo in the intake tube probably not much warmer there than where its at now

 

get one from a crv

 

Use good silocone, not the quick drying JB weld. Something that must cure for 24 hours.

 

I've said it before and now again, even in the thread Locash got deleted from. B20 screw in sensor, there are other hondas that have scerw in sensors. Just get one and weld a nut to your charge pipe. Screw it in with teflon tape, extend wires if necessary and call it done. Its not rocket science. If you use the sensor that B16/GSR have that bolt into the intake manifold you can make something up or I think Locash said he knows of something that will work with that style. Either way, sell the plug in style to another 99-00 civic owner and get a screw/bolt in style and be done. It works with the ECU so dont worry about asking that question next.