2000 civic b16b phoenix yellow |clean title| delicately moded :D new paint
looking for something new to tinker with, this car is my DD so the mileage changes, but i dont go far. there were no short cuts taken, no crappy parts put on my car, no untrained hands on my car. belive me, with the labor receipts i have, you will see what im talking about. the shop had my car longer then me, well, not really. but you get the point. i used quality as my goal, and simplicity. thanks for taking the time to check it out!
:basics:
Year: 2000
make: honda
model: civic hatch
mileage: 87,xxx
motor mileage: 88-90,000 not sure the exact.
power windows
no a/c
no p/s
:motor:
i pulled the motor when i had the car painted so i could sand and make the bay beautiful for the paint. when i put the motor back in, i reloomed the harness, and tucked it. the harness was tucked with the help of Jun from InTec racing. very few wires were cut and extended and every single wire was check for continuity after the tuck. the motor had an entire rundown, all things were check and many replaced. i wanted to do a 100,000 mile tune up befor i sold so that would not be an issue to the buyer. when i put the motor back in, i rang up about 400$ bill with the Honda of Kirkland for only bolts and fittings so i could replace the only ugly ones. thats the motors story. i have kept all receipts.
b16b
-new timing belt
-new type r water pump
-new belt tentioner
-radiator flushed
-brake fluid flushed
-clutch fluid flushed
all new liquids in the car
tons of new OEM honda bolts.
-new distributor (mine was shot) OEM brand new!
-nology hotwires w/ individual grounding straps.
-slim fan
-password:JDM CF intake
-new fule filter
-spoon res. covers
-new NGK spraks
-cat back magnaflow exhaust with a dinan tip. sounds really good.
Type r LSD tranny btw...
:Exterior:
the car came with the front bumper all messed up from a blot out, and the fender liners all ripped out. so, i replaced everything on the front end. including brand new fender liners from honda. the paint was done in a booth professionally by Jeremy of L&M autobody, the paint is PPG and the clear is PPG as well. it was baked at 165 for 10 mins. i have yet to cut and buff it, but have waxed it, unfortunately with all this snow, i havent had the chance to polish and buff. all parts are OEM honda, no off brand parts. i only wanted to purchase name brand things, to keep it quality. it has some door dings on the drivers side, 3 i think. we spent over 80 hours on the prep, as any painter will say, that's the most important part. all jams were painted, including the trunk, i removed all sound deadening materials and sanded it down. this includes the bay as well.
-OEM honda CTR headlights
-OEM honda front bumper cover
-OEM honda JDM thin side moldings
-OEM honda fenders with side markers
-OEM honda Civic Si hood bra
-OEM honda CTR grill
-OEM honda CTR rear lip
-OEM honda Power folding mirrors
-OEM honda CTR rear emblem
-OEM honda DOHC- TEC decal
-raybig JDM yellow fogs
-ViS CF hood
-Seibon CF CTR wing
-Zearth Grounding strap
-Honda Access window visors
-
:suspension:
nothing much to tell about this, it rides good, but unfortunately i have to keep my car kinda high because of my frigging driveway. so if ur wondering why its not very low, believe me, i want to lower it more!
-Front: Tein Super street coilovers
-Rear: Koni yellows w/ GC coils
-3 pt strut tower bar
-c pillar bar
-blox extended lugs (purple, on the way)
will come on steelies, love my rims to much.
:Interior:
the interior is one of the best parts, because its kinda unique in what i did. i took a dye and hit all the interior panels, except the dash, and dyed them black. it matches perfectly the actual ctr interior, and it makes it a lot cleaner on the inside. i hated the dark Grey interior. while it was being painted i pull everything except the dash. so i was able to clean under the carpet. i bought new interior fittings and put the interior back together meticulously. so its very clean inside my car at all times. i hate clutter.
-OEM honda CTR carpet
-OEM honda CTR floor mats
-OEM honda USDM ITR seats (super clean, no rips or burns)
-OEM honda CTR armrest delete
-PWJDM CTR shift boot
*circuithero Shift **** (just ordered.)
-Buddy club spec 2 racing dual bend SS
-Energy suspension Shifter bushings
-black interior
well i think thats everything... i dont know of anything else, i might be forgetting some things but i am not sure. ill edit as more things get bought and i remember other things etc. oh yeah, and the car is getting tuned soon. chipped p28 tuned on chrome on a dyno at InTec racing.
asking 10k OBO , trades are legit as well, show me what you got.
i haventhad a chance to take good pictures because right after i got it back from the shop, it started snowing... so heres what i got.




i will be getting more very soon!!! thanks guys!
:basics:
Year: 2000
make: honda
model: civic hatch
mileage: 87,xxx
motor mileage: 88-90,000 not sure the exact.
power windows
no a/c
no p/s
:motor:
i pulled the motor when i had the car painted so i could sand and make the bay beautiful for the paint. when i put the motor back in, i reloomed the harness, and tucked it. the harness was tucked with the help of Jun from InTec racing. very few wires were cut and extended and every single wire was check for continuity after the tuck. the motor had an entire rundown, all things were check and many replaced. i wanted to do a 100,000 mile tune up befor i sold so that would not be an issue to the buyer. when i put the motor back in, i rang up about 400$ bill with the Honda of Kirkland for only bolts and fittings so i could replace the only ugly ones. thats the motors story. i have kept all receipts.
b16b
-new timing belt
-new type r water pump
-new belt tentioner
-radiator flushed
-brake fluid flushed
-clutch fluid flushed
all new liquids in the car
tons of new OEM honda bolts.
-new distributor (mine was shot) OEM brand new!
-nology hotwires w/ individual grounding straps.
-slim fan
-password:JDM CF intake
-new fule filter
-spoon res. covers
-new NGK spraks
-cat back magnaflow exhaust with a dinan tip. sounds really good.
Type r LSD tranny btw...
:Exterior:
the car came with the front bumper all messed up from a blot out, and the fender liners all ripped out. so, i replaced everything on the front end. including brand new fender liners from honda. the paint was done in a booth professionally by Jeremy of L&M autobody, the paint is PPG and the clear is PPG as well. it was baked at 165 for 10 mins. i have yet to cut and buff it, but have waxed it, unfortunately with all this snow, i havent had the chance to polish and buff. all parts are OEM honda, no off brand parts. i only wanted to purchase name brand things, to keep it quality. it has some door dings on the drivers side, 3 i think. we spent over 80 hours on the prep, as any painter will say, that's the most important part. all jams were painted, including the trunk, i removed all sound deadening materials and sanded it down. this includes the bay as well.
-OEM honda CTR headlights
-OEM honda front bumper cover
-OEM honda JDM thin side moldings
-OEM honda fenders with side markers
-OEM honda Civic Si hood bra
-OEM honda CTR grill
-OEM honda CTR rear lip
-OEM honda Power folding mirrors
-OEM honda CTR rear emblem
-OEM honda DOHC- TEC decal
-raybig JDM yellow fogs
-ViS CF hood
-Seibon CF CTR wing
-Zearth Grounding strap
-Honda Access window visors
-
:suspension:
nothing much to tell about this, it rides good, but unfortunately i have to keep my car kinda high because of my frigging driveway. so if ur wondering why its not very low, believe me, i want to lower it more!
-Front: Tein Super street coilovers
-Rear: Koni yellows w/ GC coils
-3 pt strut tower bar
-c pillar bar
-blox extended lugs (purple, on the way)
will come on steelies, love my rims to much.
:Interior:
the interior is one of the best parts, because its kinda unique in what i did. i took a dye and hit all the interior panels, except the dash, and dyed them black. it matches perfectly the actual ctr interior, and it makes it a lot cleaner on the inside. i hated the dark Grey interior. while it was being painted i pull everything except the dash. so i was able to clean under the carpet. i bought new interior fittings and put the interior back together meticulously. so its very clean inside my car at all times. i hate clutter.
-OEM honda CTR carpet
-OEM honda CTR floor mats
-OEM honda USDM ITR seats (super clean, no rips or burns)
-OEM honda CTR armrest delete
-PWJDM CTR shift boot
*circuithero Shift **** (just ordered.)
-Buddy club spec 2 racing dual bend SS
-Energy suspension Shifter bushings
-black interior
well i think thats everything... i dont know of anything else, i might be forgetting some things but i am not sure. ill edit as more things get bought and i remember other things etc. oh yeah, and the car is getting tuned soon. chipped p28 tuned on chrome on a dyno at InTec racing.
asking 10k OBO , trades are legit as well, show me what you got.
i haventhad a chance to take good pictures because right after i got it back from the shop, it started snowing... so heres what i got.




i will be getting more very soon!!! thanks guys!
Last edited by teh Dirka; Jan 9, 2009 at 10:31 AM.
lol, i know my stelies are pimping, but they have a poloished lip!!! nows thats baller.
and no thanks on the TL, love them, but not from me right now, (yeah, its the 4 doors sorry lol)
heres some updated pics of the bay and the interior.


the interior.
and no thanks on the TL, love them, but not from me right now, (yeah, its the 4 doors sorry lol)
heres some updated pics of the bay and the interior.


the interior.
Trending Topics
thanks. i think 11k is pushing it. even if the steelies are JDM!
ne ways, im going to try and get exterior shots asap! thanks for the bumps and for looking!
ne ways, im going to try and get exterior shots asap! thanks for the bumps and for looking!
If I didn't love my car I would probably by this man lol. Car is super clean in person, whoever gets this wont be disappointed.
Bump for Cameron
Bump for Cameron
i have all, all, all reciepts.
from intec racing, the paint shop, honda dealers, etc. i keep all the boxes i get things from i keep all the shipping reciepts... ive got it all.
so yeah.
thanks for all the bumps and vouches guys!
dennis, you saw my car when it was all nasty and on thoes ugly steelies lol. now i have ballin steelies!
BUMP!
from intec racing, the paint shop, honda dealers, etc. i keep all the boxes i get things from i keep all the shipping reciepts... ive got it all.
so yeah.
thanks for all the bumps and vouches guys!
dennis, you saw my car when it was all nasty and on thoes ugly steelies lol. now i have ballin steelies!

BUMP!
Thread
Thread Starter
Forum
Replies
Last Post
teh Dirka
Vehicles for sale
69
Feb 26, 2010 06:13 AM
teh Dirka
Northwest (Sales)
34
Aug 21, 2009 06:27 AM
teh Dirka
Vehicles for sale
12
May 11, 2009 01:09 AM
teh Dirka
Vehicles for sale
11
Jan 20, 2009 07:30 PM
teh Dirka
Vehicles for sale
5
Jan 6, 2009 06:53 PM




