Im getting everything together for my h2b, doing my research and all and i believe i need the dc L bracket according to qsd? Is that so? Ill be using the bisimoto or evo h2b kit though but still. The bracket is the one behind the motor/trans the mates to the firewall/subframe right? I know that one sounds noobish but im just making sure haha. thanks

 

yes you will need the any hydro b series L bracket

 

Not every B series will work.

a 99+ SI bracket WILL NOT WORK.

A 94+ integra T mount is what you need

 

Awesome, thats what i was thinking.
how about the throttle cable, i havnt heard much on that. I dont know if thats because the stock d series works or what?

 

a D might work, I have an Ls one on mine, just b/c It was on my last motor. you are going to have to make a bracket where it mounts for the slack to be taken out for the throttle blade, I had to customize my skunk2 throttle bracket for my h2b with the Ls throttle cable. For the throttle cable, I don't think there is a real good answer, but like the others said, you need an sir2 or a 94-01 teg rear L bracket.

 

Great, just what im looking for. I could fab a simple cable mount with some 1/8 or smaller flat steel or something easy.

 

Thats all you need. Good luck on your project.

 

Your stock cable will work just flip the bracket on the intake mani around and you have to bend the one on the shock tower down a little. Here is a pic of mines

 

a 99 si bracket will work thats what im using in my 92 hatch

 

I also heard the 99-00 si bracket was a little different and wouldnt work. I would just stick to an integra one

 

Well let's put it this way, a 99-00 Si would be way to short on my setup with the Evolution kit.

 

are you using a EK crossmember?

 

does any one know which L braket will I need if I am useing the qsd kit into a ef chassis ?

 

This question gets asked a lot and is our FAQ.

The L (or T as some call it) used is the same one you would use if you were doing a B swap into your chassis. The tranny does not relocate therefore neither does the L (or T) bracket.

So which bracket would you use for a EK with a GSR swap? A 99+ SI bracket is needed, which is also need to do the H2B.

 

DA rear bracket...