4x cable ef trans, zc, si, dx, jdm d15b motor, ls cranks, chipped pm6
Thread Starter
Honda-Tech Member
Joined: Aug 2005
Posts: 1,460
Likes: 2
From: NY, USA
4x cable ef trans, zc, si, dx, jdm d15b motor, ls cranks, chipped pm6, log manifold
autoworks log manifold for d series, put about 20k on it. cracked in the middle but rewelded and mint. $200 obo
OR COMPLETE TURBO SETUP, this setup went 12.2@110 on a vitara motor. with a good tune easy 11s on a decent build. i bought the turbo used and i put abiyt 7500 miles on it. its mint and tough, uses standard t3 lines. no smoke and super tight shaft, tightest turbo ive ever had.
autoworks log mani, borg warner gm-3 turbo, stainless 3" downpipe with manual cut-out (homemade) $350!!!
i have 4 cable d series trannies.
1x dohc zc trans, comes with zc halfshaft, uses 90-93 teg axles $200obo
1x 90-91 si trans 90-100k $150obo
1x 90-91 dx trans $100
1x 88 dx trans $75
ill throw in a starter with every tranny.
ive run all the trans myself except for the one 90-91 dx, which was in a friends car. all shifted perfect, all gears good, no noise at idle, no grinds.
xenocron chipped pm6 ecu, set up for 4 pin datalogger. $75
1x b18a1 crank $50?? best offer
complete d16a6 intake manifold with sensor and tb, $30
complete b18a1 5spd intake mani with tb, all sensors good, $50
bare b18b1 intake mani $20
pickup/delivery only.
OR COMPLETE TURBO SETUP, this setup went 12.2@110 on a vitara motor. with a good tune easy 11s on a decent build. i bought the turbo used and i put abiyt 7500 miles on it. its mint and tough, uses standard t3 lines. no smoke and super tight shaft, tightest turbo ive ever had.
autoworks log mani, borg warner gm-3 turbo, stainless 3" downpipe with manual cut-out (homemade) $350!!!
i have 4 cable d series trannies.
1x dohc zc trans, comes with zc halfshaft, uses 90-93 teg axles $200obo
1x 90-91 si trans 90-100k $150obo
1x 90-91 dx trans $100
1x 88 dx trans $75
ill throw in a starter with every tranny.
ive run all the trans myself except for the one 90-91 dx, which was in a friends car. all shifted perfect, all gears good, no noise at idle, no grinds.
xenocron chipped pm6 ecu, set up for 4 pin datalogger. $75
1x b18a1 crank $50?? best offer
complete d16a6 intake manifold with sensor and tb, $30
complete b18a1 5spd intake mani with tb, all sensors good, $50
bare b18b1 intake mani $20
pickup/delivery only.
Last edited by AJxr; Dec 9, 2008 at 03:49 PM.
Thread Starter
Honda-Tech Member
Joined: Aug 2005
Posts: 1,460
Likes: 2
From: NY, USA
Re: 4x cable ef trans, zc, si, dx, jdm d15b motor, ls cranks, chipped pm6, log manifold (blackeg)
bump, they just salted my roads and there isnt even snow out there. season is over!
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
bergercurtis
Honda CRX / EF Civic (1988 - 1991)
4
Feb 19, 2016 01:54 PM
55superbeetle
Northern California (Sales)
1
Jan 24, 2008 05:02 PM
headhunter
Honda CRX / EF Civic (1988 - 1991)
10
Jun 26, 2006 03:42 PM
