This is proabably easy but i'm not sure, got my old shifter out with no problem and trying to install this new B&M shifter but the holes from where i took the bearing or pivot out(not sure what its call aren't the same size! Is it the wrong part?
This is for a 99 civic si

http://s93.photobucket.com/alb...parts/


Modified by rutherfordhigh at 2:27 PM 10/25/2008

 

if the holes dont line up u got the wrong shifter

 

could i go to an auto store and get a smaller ball bearing to make them line up


Modified by rutherfordhigh at 2:25 PM 10/25/2008

 

doubt it...
there are different ones for sohc and dohc

 

any other opinions, or does that sound right


Modified by rutherfordhigh at 2:44 PM 10/25/2008

 

bump anyone

 

So your saying the hole that goes through the bottom of the shifter is smaller than the holes on the shift linkage?