My main question is will they clear the rotors and calipers and associated hardware? I have done so much research, and if the answer to this question is no, then all my searching is a waste and I will have rims to sell... Haha.

 

Oh yeah, sorry, Si hatchback, rear drums, stock front brakes.

 

13 is stock.. least for my year

 

What model do you have? I have the 14" steelies with OEM hub caps.

 

my 89 DX hatch has 13's on it and from what i can tell they fit fine haha

 

i woul not see much of a problem with them fitting

 

Cool, thanks for the little hits. I just don't want to proceed to the next step if I don't have this base covered.

 

It all depends on the offset and wheel design. Most likely, yes they will however it all depends on the wheel. Any factory Honda wheel will fit.

 

Si's came stock with 14 steelies and hubcaps.


13's should fit, but like what was stated earlier it also depends on the offset.

 

my 13inch steelies off my 89 hatch back fit just fine looked bad but they fit

 

"It all depends on the offset and wheel design. Most likely, yes they will however it all depends on the wheel. Any factory Honda wheel will fit. "


This is not true. I tried to use my 81 Civic full size 13in spare (it is still almost new, LOL) on my 89 DX HBK, (which used 13 in.) rather than use the doughnut, it did not clear the caliper.

 

Well the offset is a modest +38mm

 

try it....

 

I want to, but I have to plug the hubs, and drill new holes...

 

i got some 13x7 +27 to fit on my dx brakes, not sure if the si and the dx brakes are different in size. lmk on those hub caps